Panasonic KXTG7923E Operating Guide
R To cancel a selected handset, press
the same dial key again. “ ”
disappears.
disappears.
4
MOKN
5
Select a memory location by pressing 1
to 6. a MOKN
to 6. a MOKN
6
Enter the phone number or area code to
be restricted (8 digits max.). a MOKN a
MeN
R To erase a restricted number, press
be restricted (8 digits max.). a MOKN a
MeN
R To erase a restricted number, press
MCN.
Changing the base unit PIN
(Personal Identification Number)
(Personal Identification Number)
Important:
R If you change the PIN, please make note of
R If you change the PIN, please make note of
1
M
N (right soft key) #132
2
Enter the current 4-digit base unit PIN
(default: “0000”).
(default: “0000”).
3
Enter the new 4-digit base unit PIN. a
MOKN
MOKN
4
MbN: “Yes” a MOKN a MeN
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations may not be
available.
on page 4. If another handset model is
used, certain operations may not be
available.
Registering a handset to the
base unit
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
M
M
N (right soft key) #130
2
Base unit:
Press and hold M
Press and hold M
N for about 5 seconds,
until the registration tone sounds.
R If all registered handsets start ringing,
R If all registered handsets start ringing,
press M
N again to stop, then repeat
this step.
R The next step must be completed
within 90 seconds.
3
Handset:
MOKN a Wait until “Base PIN” is
displayed. a Enter the base unit PIN
(default: “0000”). a MOKN
R If you forget your PIN, see page 47.
R When the handset has been registered
MOKN a Wait until “Base PIN” is
displayed. a Enter the base unit PIN
(default: “0000”). a MOKN
R If you forget your PIN, see page 47.
R When the handset has been registered
successfully,
is displayed.
Note:
R While registering, “Base in
R While registering, “Base in
registering” is displayed on all
registered handsets.
registered handsets.
R When you purchase an additional handset,
refer to the additional handset’s installation
manual for registration.
manual for registration.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
M
N (right soft key) #131
R All handsets registered to the base unit
are displayed.
2
MbN: Select the handset you want to
cancel. a MOKN
cancel. a MOKN
3
MbN: “Yes” a MOKN
R A confirmation tone sounds.
R The handset does not beep when
R A confirmation tone sounds.
R The handset does not beep when
cancelling its own registration.
32
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
Programming
TG78xx_79xxE(en)_0407_ver112.pdf 32
2015/04/07 11:32:51