Panasonic PT 60LCX63 Operating Guide

Basic Operation

The input mode changes each time this
button is pressed.

Video 1

Signal of source connected to INPUT 1 is displayed.

Video 2

Signal of source connected to INPUT 2 is displayed.

Video 3

Signal of source connected to INPUT 3 is displayed.

Comp 1

Signal of source connected to COMPONENT VIDEO INPUT 1 is displayed.

Comp 2

Signal of source connected to COMPONENT VIDEO INPUT 2 is displayed.

Comp 3

Signal of source connected to COMPONENT VIDEO INPUT 3 is displayed.

RGB 1

Signal of source connected to RGB IN 1 is displayed.

RGB 2

Signal of source connected to RGB IN 2 is displayed.

HDMI

Signal of source connected to HDMI IN is displayed.

Video 1*

Video 2*

Video 3*

Comp 1*

HDMI*

RGB 2*

RGB 1*

Comp 3*

Comp 2*

Card input mode (Photo Viewer) is
selected.

The input source for picture signals can be changed by pressing TV/VIDEO, SD on the Remote
Control or CH up/down on the unit.

Changing the input signal

Device display operation

* If SKIP is set as the Input Label setting

of Channel Caption, the mode will not be
changed. (See page 69.)

Changing input is only possible if
Cable/Antenna is set as the Input Set
setting.

Remote Control

Device display Unit

Antenna A

Antenna B*

By pressing Channel Up/Down buttons
together, you can switch between TV
mode and an outside input source.

Input changes to the fi rst outside input
source of the Input Label not set to SKIP.
For example, if Video 1 is set to SKIP, input
is changed to Video 2. See the chart, below
(except for Photo mode).

Video 1*

Photo (Photo Viewer) Signal of source connected to CARD SLOT is displayed.

While Photo Viewer is displayed, the
channel or outside input source last
viewed is redisplayed.