Panasonic KXTG8421FX Operating Guide
Useful Information
54
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect
the base unit’s AC adaptor and turn off the handset, then reconnect the base unit’s
AC adaptor and turn on the handset.
the base unit’s AC adaptor and turn off the handset, then reconnect the base unit’s
AC adaptor and turn on the handset.
General use
Problem
Cause/solution
The handset does not
automatically turn on after
installing/replacing batteries.
automatically turn on after
installing/replacing batteries.
L
The battery is empty or too weak to turn on the
power. Place the handset on the base unit or
charger, and let it charge.
power. Place the handset on the base unit or
charger, and let it charge.
The unit does not work.
L
Make sure the batteries are installed correctly
(page 11).
(page 11).
L
Fully charge the batteries (page 11).
L
Check the connections (page 11).
L
Unplug the base unit’s AC adaptor to reset the
unit and turn off the handset. Reconnect the
adaptor, turn on the handset and try again.
unit and turn off the handset. Reconnect the
adaptor, turn on the handset and try again.
L
The handset has not been registered to the
base unit. Register the handset (page 32).
base unit. Register the handset (page 32).
The handset display is blank or
dark.
dark.
L
The handset is in screen saver mode (page
16). Activate the handset display again by:
– pushing the joystick left {<} or right {>}
16). Activate the handset display again by:
– pushing the joystick left {<} or right {>}
when on a call.
– pressing {ih} at all other times.
L
“LCD in charging” is set to “Off” while on
charge. Change the setting (page 26).
charge. Change the setting (page 26).
L
The handset is not turned on. Turn the power
on (page 16).
on (page 16).
TG8411-8421FX(e).book Page 54 Tuesday, March 3, 2009 2:54 PM