Panasonic KXTGA648FX Operating Guide
5
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {ic} for
few seconds to turn the handset on.
few seconds to turn the handset on.
1
Handset:
Lift the handset and press {ic}.
Lift the handset and press {ic}.
2
Base unit:
Press and hold {x} for about 5 seconds, until the registration tone sounds.
• If all registered handsets start ringing, press the same button to stop. Then
Press and hold {x} for about 5 seconds, until the registration tone sounds.
• If all registered handsets start ringing, press the same button to stop. Then
repeat this step.
3
Handset:
Place the handset on the base unit.
• Continue the operation even when the handset display shows
Place the handset on the base unit.
• Continue the operation even when the handset display shows
“Please wait for 1 minute.”.
4
With the handset still on the base unit, wait until a confirmation tone sounds
and w stops flashing.
and w stops flashing.
Note:
• If an error tone sounds, or if w is still flashing, register the handset according
• If an error tone sounds, or if w is still flashing, register the handset according
to the base unit’s operating instructions.
For your safety
To prevent severe injury and loss of life/property, read this section carefully before using the
product to ensure proper and safe operation of your product.
product to ensure proper and safe operation of your product.
WARNING
Power connection
• Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may
• Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may
cause electric shock and/or excessive heat resulting in a fire.
• Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the
power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation
defect from moisture, etc. resulting in a fire.
defect from moisture, etc. resulting in a fire.
• Unplug the product from power outlets if it emits smoke, an abnormal smell, or makes an
unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has
stopped emitting and contact an authorised service centre.
stopped emitting and contact an authorised service centre.
Installation
• To prevent the risk of fire or electrical shock, do not expose the product to rain or any type
• To prevent the risk of fire or electrical shock, do not expose the product to rain or any type
of moisture.
• Do not place or use this product near automatically controlled devices such as automatic
doors and fire alarms. Radio waves emitted from this product may cause such devices to
malfunction resulting in an accident.
malfunction resulting in an accident.
Operating safeguards
• The use of excessive sound volume through earphones, headphones, or headsets may
• The use of excessive sound volume through earphones, headphones, or headsets may
cause hearing loss.
TGA648FX(fx).book Page 5 Tuesday, June 9, 2009 3:35 PM