Panasonic NVMD10000GC Operating Guide

Before using

VQT0S76

ª

If 2 cameras are used simultaneously, set the mode for one pair 
of movie camera and remote control to [VCR1] and that of the 
other pair to [VCR2]. This will prevent interference between the 
2 pairs. (The default setting is [VCR1]. When the button-type 
battery is replaced, the setting will revert to the default [VCR1].) 

D] and [∫] simultaneously. 1

E] and [∫] simultaneously. 2

ª

≥When the button-type battery runs down, replace it with a new 

battery (part number: CR2025). The battery is normally 
expected to last about 1 year, but it depends on operation 
frequency.

≥Keep the button-type battery out of the reach of children.

≥If the remote control mode of the camera and that of the 

remote control do not match with each other, “REMOTE” will 
appear. When the remote control is operated for the first time 
after the camera is turned on, “CHECK REMOTE MODE” 
(

) will appear and operation is impossible. Set the same 

remote control mode.

≥The remote control is intended for indoor operation. Outdoors 

or under strong light, the movie camera may not operate 
properly even within the usable ranges.

≥Within a 1 metre range, you can operate the remote control 

from beside the remote control sensor (LCD monitor side) of 
the movie camera.

ª

Supplied external stereo microphone can be switced to record 
sound in either stereo or monaural.

(1)

(2)

(3)

(4)

(5)

(6)

(7)

ª

≥Press the [

] mark on the cover in the direction of arrow 

1 and slide the cover in the direction of arrow 2.

s) end first as shown in the 

≥Be sure to insert the Battery with the (j) and (i) ends 

facing the proper directions.

≥When the battery is exhausted, purchase a new “AAA”, 

“UM-4” or “R03” type battery and insert it in the same way as 
explained above.

≥Do not short-circuit the battery.
≥Remove the Battery if you will not use the microphone for one 

month or longer.

2

1

      

   

1

2

-

+

Eng_Body.fm  51 ページ  ２００５年７月２１日　木曜日　午後１時２３分