Panasonic KXUDS124 Operating Guide
3.2 Connecting SIP Cell Stations
Connecting a SIP-CS to a LAN
Notice
•
Connect the SIP-CSs to the LAN only after completing network settings. For details about network
settings, see "Configuring Network Settings for Super Master CS" in "4.3 Site Survey".
•
When connecting a SIP-CS to the LAN, connect it to a switching hub.
Note
•
Use an Ethernet straight cable with an RJ45 connector to connect the SIP-CS to a switching hub. The
cable should be a 10BASE-T/100BASE-TX CAT 5 (Category 5) or higher cable, and the diameter of
the cable must be 6.5 mm or less.
•
It is possible to connect the SIP-CS to the LAN while registering the SIP-CS to the SIP server.
1.
Connect the cable to the SIP-CS.
Ethernet Cable
2.
Pass the cable through the groove of the SIP-CS in one of the following three ways.
To a Switching Hub
To a
Switching
Hub
Switching
Hub
To a Switching Hub
1
2
3
1
3.
Connect the other end of the cable to the switching hub.
16
Installation Guide
3 Installing the SIP Cell Stations
16
Upute za postavljanje
3.2 Spajanje SIP-baznih stanica
Spajanje SIP-BS-a na LAN
Napomena
• Spojite SIP-BS-ove na LAN tek nakon što podesite mrežu. Detalje o mrežnim postavkama potražite u
dijelu „Konfiguracija mrežnih postavki centralnog nadređenog BS-a" pod „4.3. Pregled mjesta".
• Kada spajate SIP-BS na LAN, spojite ga na komutacijsko čvorište.
Napomena
• Koristite ravni kabel za ethernet s priključkom RJ45 da biste spojili SIP-BS na komutacijsko čvorište.
Kabel treba biti 10BASE-T/100BASE-TX CAT 5 (kategorija 5) ili više kategorije, a promjer kabela
mora biti 6,5 mm ili manji.
• Moguće je spojiti SIP-BS na LAN dok se SIP-BS registrira na SIP-poslužitelj.
1.
Spojite kabel na SIP-BS.
3 Postavljanje SIP-baznih stanica
Kabel za ethernet
U komutacijsko čvorište
U komutacijsko čvorište
U
komutacijsko
čvorište
2.
Provucite kabel kroz utor SIP-BS-a na jedan od sljedeća tri načina.
3.
Spojite drugi kraj kabela u komutacijsko čvorište.