Panasonic pv-dr2714 Operating Guide
33
VCR
Operation
1
Press SEARCH in Playback or Stop mode to display
INDEX SEARCH screen, and then press NUMBER
keys to select the recording number.
keys to select the recording number.
Go directly to the desired recording.
Note:
• If Index Search is started very close to an index mark, that index
mark may not be counted in the search.
3
Play begins at search end. To search forward or
back 1 index, press FF or REW while screen below
is displayed (10 seconds).
is displayed (10 seconds).
NOTE: ↓ indicates start points of each recording.
Example 2:
To cancel,
press STOP.
6
1
5
7
2
3
4
1
7
5
3
4
6
2
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
To go to rec. 2 from rec. 4, enter 3 and press REW.
To go to rec. 6 from rec. 2, enter 4 and press FF.
INDEX SEARCH
ENTER INDEX NUMBER :1
USING 1-9 KEYS
USING 1-9 KEYS
FORWARD SEARCH :FF
REVERSE SEARCH :REW
REVERSE SEARCH :REW
EXIT :RETURN
INDEX SEARCH
FORWARD SEARCH :FF
REVERSE SEARCH :REW
REVERSE SEARCH :REW
Index Search
2
Press FF or REW to start search.
Search System is ...
Each time a recording is made, an invisible index mark is placed
on the tape. When timer recordings are made, program index
and information are also included. These index marks can be
used to access or scan recordings.
2
Press AUDIO repeatedly (each press within 5
seconds) to select desired mode.
• Select “HIFI (L/R),” to listen to a regular Hi Fi Stereo recording.
Select “HIFI (L)” or “HIFI (R)” to listen only to the left or right channel
of a stereo recording. This is commonly used for Karaoke, music
on one channel and vocal on the other. Select “NORMAL” for linear
stereo playback from a recorded tape with Hi Fi disabled.
of a stereo recording. This is commonly used for Karaoke, music
on one channel and vocal on the other. Select “NORMAL” for linear
stereo playback from a recorded tape with Hi Fi disabled.
• This screen appears when you press AUDIO during playback.
1
See the “Playback a Tape” section on page 32 to
playback the tape.
Choose the type of sound track for playback.
HIFI(L/R)
HIFI(L)
HIFI(R)
NORMAL
HIFI(L)
HIFI(R)
NORMAL
Audio Mode for Playback
To quickly return to a specific tape counter location.
4
Press
STOP.
3
Continue to record, playback etc.
2
While (counter is displayed), Press COUNTER
RESET at the desired position to reset to “0:00.00.”
1
Press COUNTER RESET during playback to display
the Counter.
5
Press CM/ZERO in Stop mode to start ZERO
SEARCH.
• Unit will go into FF or REW mode and stops at the last point the
Counter was set to 0:00.00.
0:00.00
Zero Search