Panasonic AG520E Operating Guide

Display
Picture Tube:

13 inch (AG-513E)
20 inch  (AG-520E)
measured diagonal 90

°

deflection Picture Tube

VCR
Video Recording System: 4 rotary heads helical

scanning system

Audio Track:

1 track

Tuner
Broadcast Channels:

VHF 2 ~ 13, UHF 14 ~ 69

CABLE Channels:

Midband A through I (14 ~ 22)
Superband J through W
(23 ~ 36)

Hyperband AA ~ EEE (37 ~ 64)
Lowband A-5 ~ A-1 (95 ~ 99)

Special CABLE channel 5A (01)
Ultraband 65 ~ 94, 100 ~ 125

General
Power Source:

120 V AC, 60 Hz

Power Consumption:

Power On
Approx. 69 watts (AG-513E)
Approx. 110 watts
(AG-520E)
Power Off
Approx. 4.0 watts

Television System:

EIA Standard NTSC color

Speaker:

1 piece

Operating Temperature: 5 

°C ~ 40 °C (41 °F ~ 104 °F)

Operating Humidity:

10 % ~ 75 %

Weight:

12 Kg (26.4 lbs.) (AG-513E)
23 Kg (50.7 lbs.) (AG-520E)

Dimensions:

386 (W) X 385 (H) X
374 (D) mm
15-3/16” (W) X 15-3/16” (H)
X14-3/4” (D) (AG-513E)
515 (W) X 505 (H) X
474 (D) mm
20-5/16” (W) X 19-7/8” (H)
X 18-11/16” (D) (AG-520E)

Note: Designs and specifications are subject to

change without notice.

Unit auto adjusts clock for DST (Daylight Saving
Time.)

■ Spring (First Sunday in April)

DST : ON 

➜ Sets clock ahead one hour.

■ Autumn (Last Sunday in October)

DST : ON 

➜ Turns clock back one hour.

• If your area does not observe Daylight Saving

Time, select DST:OFF (see “Clock” on pages
12 and 13.)

• Keep these time changes in mind when

programming the unit for timer recordings.

Digital Auto Tracking
Continuously analyzes the signal and adjusts
for optimum picture quality.

Manual Tracking Control (to reduce picture
noise)
Use during Playback and Slow Motion mode to
reduce picture noise. Press the 3 or 6 number
key on the remote control or CH 

 on the

unit until the picture clears up. To return to
Auto Tracking, press POWER off, then on
again a few seconds later.

V-Lock Control
In Still mode, the 3 or 6 number key on the
remote control or CH 

 on the unit operate

as a V-Lock control to reduce jitter.

PanaBlack Picture Tube
<For Model AG-520E only>
This unit uses a PanaBlack picture tube for
better color reproduction and picture contrast.

When moving unit to a new location, or if a
mistake was made in the Initial Setup section.

• Make sure a tape is not inserted in the unit.

Turn the unit
Power on.

Do “Initial Setup” on pages 9 - 11.

Press and hold both PLAY and FF on
the unit for more than 5 seconds.

• The power will shut off.
• Please ignore “NO CASSETTE” warning.

<Model AG-520E unit shown>