Panasonic RPWF6000 Operating Guide

RQT881

1

10

11

RQT881

1

     Pull the free-adjusting band i and check if the OPR lamp j on the right housing 

k 

is dim or off. This means that the battery has run down and should be charged 

or replaced.

     If the sound is distorted, intermittent or there is excessive background noise while 

using the headphones, the battery should be charged or replaced.

     The  supplied  nickel-metal  hydride  rechargeable  battery  can  be  recharged 

approximately 300 times. If the operation time of the battery becomes extremely 

short  after  charging,  the  battery’s  service  life  has  reached  the  end.  Be  sure  to 

replace it with the dedicated rechargeable battery RP-BP6000 (optional).

     Do not pull up the free-adjusting band i when not using the headphones. This may 

cause the auto power on/off function to switch the headphones back on and battery 

power to run down.

When connecting the optical DIGITAL AUDIO OUT terminal of, for example, a portable DVD player or portable CD 

player to the transmitter’s DIGITAL IN 1 or 2 terminal, use the optional digital cable (mini plug to angular plug) or 

similar.

*

1

 Operation is not guaranteed when connecting to a computer’s optical DIGITAL AUDIO OUT terminal.

*

2

 When the connected equipment supports PCM output only, the surround sound will become DOLBY PRO LOGIC II.

Use “LR6, AA” alkaline dry cell batteries. Put the 2 alkaline dry cell batteries into the headphones in the same way 

as described in [Inserting the supplied nickel-metal hydride rechargeable battery] (

 page 8).

You cannot charge dry cell batteries even if you put the headphones on the transmitter.

● Before connecting, turn off the digital or analogue equipment.

●  

● Refer/Read to the operating instructions of the connected equipment.

Use  the  supplied  optical  digital  cable  to  connect  a  television  or  DVD  player’s*

1

  optical  DIGITAL AUDIO  OUT 

terminal*

2

 to the transmitter’s DIGITAL IN 1 or 2 terminal.

     If you connect optical digital output equipment to the DIGITAL IN 1 and DIGITAL IN 2 terminals and an AV 

amplifier (not included) to the DIGITAL OUT terminal, you can switch the input without changing the optical 

digital cable.

    ●  You can select the signal input to this unit and the signal output to the connected equipment at the same time 

with the INPUT SELECT control. When ANALOG is selected, the signal input to DIGITAL 2 is output to the 

connected equipment (AV amplifier, etc.). (

 page 6)

    ● The input signal cannot be switched if the AC adaptor is not connected to the transmitter.

     Check that the left and right sides of the headphones are correctly placed on the left and right sides of the 

transmitter.

     Check that the charging terminals on the headphones and transmitter are touching each other. Adjust them if 

they are not touching.

    ●  When there is dirt on the charging terminals of the headphones or the transmitter, remove it gently with a 

cotton bud, etc.

    Put the headphones back on the transmitter. The OPR/CHARGE lamp glows red and charging begins.

*

1

 At 1 kHz, 1 mW + 1 mW output.

*

2

  Operating times may differ depending on the temperature of the surrounding environment and operating 

conditions.

Panasonic Alkaline batteries

Approx. 6 hours *

2

Remove the plug caps and insert the 

cable firmly into the correct terminals.