Panasonic SV-AP10U Operating Guide

Page of 58
Preparation
8
Inserting Remote Control Batteries
1
While pressing the indentation 
 in the 
direction indicated by the arrow, lift the 
cover up.
2
Insert the batteries (supplied) with the 
polarity (
 and 
) correctly aligned.
3
Cover is returned.
Precautions for Battery Replacement 
The service life of the batteries is approximately 1 year.
However, it varies considerably depending on the 
frequency of use.
p
When they are exhausted, replace them with two AA, 
UM3, or R6 size batteries.
p
When the batteries are exhausted, remove them 
immediately and dispose of them correctly.
p
Make sure that the batteries are inserted with the 
polarity (
 and 
) correctly aligned.
p
Do not mix old battery with new battery.
p
Do not mix different battery types, i.e. Alkaline and 
Manganese.
p
Do not use rechargeable (Ni-Cd) batteries.
p
Do not heat or short-circuit the batteries.
p
When you do not use the remote control for a long time, 
take out the batteries and store them in a cool, dry 
place.
Using the Remote Controller
1
Direct the remote controller at the remote 
control receiver 
 and press a button on 
the remote controller.
p
Distance from the Photo Printer: Within approximately 
23 feet (7 m)
p
Angle: Within approximately 40 degrees in the vertical 
direction and 60 degrees in the horizontal direction from 
the central axis
p
Do not put an the obstruction between the Photo Printer 
and remote controller.
p
Do not expose the remote control receiver to direct 
sunlight or strong light. 
p
When attaching the paper cassette, you cannot use the 
remote controller from the right angle or lower right 
angle.
p
The receiver range reverses between the Vertical and 
Horizontal layout.
CAUTION
Danger of explosion if battery is incorrectly 
replaced.
Replace only with the same or equivalent type 
recommended by the manufacturer.
Dispose of used batteries according to the 
manufacturer’s instructions.