Panasonic th-50pv500ey Operating Guide

Page of 1
TQB0E9003
TH-37PV500EY
TH-42PV500EY
TH-50PV500EY
The following procedures are in addition to those given in the Operating instructions.
Please follow them when installing your TV set for the fi rst time.
OSD Language is English only.
 Mains Lead
The supplied mains lead is a three-pin type, not the type shown on page 6.
IMPORTANT: THE MOULDED PLUG
FOR YOUR SAFETY, PLEASE READ THE FOLLOWING TEXT CAREFULLY.
This appliance is supplied with a moulded three pin mains plug for your safety 
and convenience. A 5 amp fuse is fi tted in this plug. Shall the fuse need to be replaced, please ensure 
that the replacement fuse has a rating of 5 amps and that it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark 
ASA
 or the BSI mark   on the body of the fuse.
If the plug contains a removable fuse cover, you must ensure that it is refi tted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic Dealer.
If the fi tted moulded plug is unsuitable for the socket outlet in your home, then the fuse shall be 
removed and the plug cut off and disposed of safety. There is a danger of severe electrical shock 
if the cut off plug is inserted into any 13 amp socket.
If a new plug is to be fi tted, please observe the wiring code as shown below.
If in any doubt, please consult a qualifi ed electrician.
WARNING 
: – THIS APPARATUS MUST BE EARTHED.
IMPORTANT : – The wires in this mains lead are coloured in accordance with the following code: – 
 
Green-and-Yellow:  Earth      Blue: Neutral      Brown: Live
As the colours of the wire in the mains lead of this appliance may not correspond with the coloured 
markings identifying the terminals in your plug, proceed as follows.
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug 
which is marked with the letter E or by the Earth symbol 
 or coloured GREEN or GREEN-AND-
YELLOW.
The wire which is coloured BLUE must be connected to the terminal in the plug 
which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the 
plug which is marked with the letter L or coloured RED.
How to replace the fuse. 
Open the fuse compartment with a screwdriver and replace the fuse.
 Quick Start Guide 
(Step 3 on page 9)
Programmes will appear immediately if your dealer has programmed the TV for you.
If the TV has not been programmed for you then Auto setup will begin.
TV stations will be located, sorted into order and stored ready for use.
Additional informations for the Republic of Ireland