Panasonic TXL55WT65B Operating Guide
- 88 -
Note
●
TV Guide may also be used to set timer programming event.
●
Timer Programming
can store up to 15 events.
●
Timer Programming
only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
For recording using
Timer Programming
, the TV must be either on or in
Standby. For reminders to be displayed, the TV must be on.
●
Depending on the progress of recording, analogue channel may not be
selected.
●
Recording an encrypted (copy-protected) programme may not be possible.
●
2 minutes before the starting time, a reminder message may appear if you
are watching TV.
– To remove the message and start the programming, press
– To remove the message and start the programming, press
OK
.
– To cancel the programming, press
EXIT
.
●
LED will turn to orange in Standby mode if
Timer Programming
is set.
●
Timer Programming
reminder messages will remain displayed until one of
the following occurs:
– You press
– You press
OK
to view the programme or
EXIT
to cancel the reminder.
– The timer programming event that the reminder is set for ends.
●
“!” identifies that three or more timer programming events are overlapped.
USB HDD Rec.
is given priority over
Reminder
. As for the overlapped
recording events, the first event starts and finishes as programmed. The
next event can then start.
●
The recording of
Timer Programming
may automatically change the
channel to the programmed channel a few seconds before the starting
time.
●
The recording of
Timer Programming
will be performed even if the TV is in
Rewind LIVE TV
recording. In this case,
Rewind LIVE TV
recording will be
cancelled.
●
For more information of the USB HDD