Toshiba 49" Toshiba Ultra HD WLAN TV Important Safety Instructions

English - 22 -

3 AM search and upgrade mode

Your TV will search for new upgrades at 3:00 o’clock if

Automatic scanning option in the Upgrade options

menu is set to

Enabled and if the TV is connected

to an aerial signal or to Internet. If a new software is

found and downloaded successfully, it will be installed

at the next power on.

Note: Do not unplug the power cord while led is blinking

during the reboot process. If the TV fails to come on after the

upgrade, unplug, wait for two minutes then plug it back in.

Troubleshooting & Tips

Tv will not turn on

Make sure the power cord is plugged in securely to
a wall outlet. Press the Power button on the TV.

Poor picture

• Check if you have correctly tuned the TV.
• Low signal level can cause picture distortion. Please
check antenna connections.
• Check if you have entered the correct channel

frequency if you have performed manual tuning.

No picture

• TV is not receiving any signal.
Make sure the correct source has been selected.
• Is the antenna connected properly?
• Is the antenna cable damaged?
• Are suitable plugs used to connect the antenna?
• If you are in doubt, consult your dealer.

No sound

• Check if the TV sound is muted. Press the Mute

button or increase the volume to check.

• Sound is coming from only one speaker. Check the

balance settings from Sound menu.

Remote control - no operation

• The batteries may be exhausted. Replace the

batteries.

• The batteries maybe inserted incorrectly. Refer to

the section "Inserting the Batteries into the Remote".

No signal on an input source

• It is possible that no device is connected.
• Check the AV cables and connections from your

device.

• Check the device is switched on.

Recording unavailable

To record a programme, you should first correctly

connect a USB storage device to your TV, while the

TV is switched off. You should then switch on the TV

to enable the recording feature. If you cannot record,

check the storage device is correctly formatted and

there is sufficient space.

USB is too slow

If a “USB storage device writing speed too slow to

record” message is displayed on the screen while

starting a recording, try restarting the recording. If you

still get the same error, it is possible that your USB

storage device does not meet the speed requirements.

Try using a different USB storage device.