ESTeem AA195PM Pole Mount Kit Specification Guide
TECHNICAL BULLETIN
AA195PM ASSEMBLY
ELECTRONIC SYSTEMS TECHNOLOGY
509-735-9092 (O)
415 N. QUAY STREET
• KENNEWICK, WA 99336
Page 1 of 5
www.esteem.com
Revised 18 May 07
ASSEMBLING THE AA195PM TWO HOLE OUTDOOR POLE MOUNTING KIT
The AA195PM mounting kit contains everything required for pole mounting and weatherproofing the ESTeem Model 195Eg for
outdoor installations. The 195Eg with AA195PM mounting kit can be directly mounted to a round pole up to a maximum diameter of
2” OD. Any mounting structure greater than 2” requires hose clamp strapping run through the Pole Mount Brackets. The mounting
kit requires the following assembly:
outdoor installations. The 195Eg with AA195PM mounting kit can be directly mounted to a round pole up to a maximum diameter of
2” OD. Any mounting structure greater than 2” requires hose clamp strapping run through the Pole Mount Brackets. The mounting
kit requires the following assembly:
1. If you purchased an AA195PM mounting kit with your Model 195Eg, the kit will be packed in the same packing box as the
ESTeem (Figure 1).
2. Remove and inventory the two (2) Pole Mounting Brackets, one (1) Two-Hole Face Plate Cover (with single port cover installed),
one (1) Heat Shield and (1) AA195PM Hardware bag from the packing box (Figure 1). Report any missing or damaged items to
ESTeem Customer Support (509-735-9092 Phone) as soon as possible for replacement.
ESTeem Customer Support (509-735-9092 Phone) as soon as possible for replacement.
Figure 1: Packet Box Contents
Figure 2: AA195PM Hardware Contents
(2) Square Bend U-Bolts with Hardware
(2) Pole Mount Clamps
(4) 10-24 Pan Screws
(2) Ethernet
Cable Boot
(1) Weather Proof
Boot for Antenna
Port B (if not used)
(2) Direct Mount Antenna Boots for ESTeem
Approved Direct Mount Antenna Only