Weed Instrument MXCC-IP2 Input Module Specification Guide
Safety and Warning Information
Connect the DIN Rail, via the Model
2A09 End Clamp, to Protective Earth
(PE) ground with low impedance.
ATEX Specific Conditions of Use
Modules shall be installed in an enclosure which
maintains an ingress protection rating of IP54 and
meets the enclosure requirements of EN60079-0 and
EN60079-15. The EOTec modules shall be installed
in DIN rail with DIN end clamps mounted on both
sides of the module set. The DIN rail must be
connected to Protective Earth in order to provide
modules with a Protective Earth connection. Do not
disconnect equipment connections or modules when
energized.
Ultra Electronics
N
UCLEAR SENSORS & PROCESS INSTRUMENATION
707 Jeffery Way, PO Box 300
Round Rock, TX 78680-300 USA
Toll Free: 800-880-9333
Toll Free: 800-880-9333
Telephone: +1 512-434-2850
Fax: +1 512-434-2901
Email: fiberop@ultra-nspi.com
Email: fiberop@ultra-nspi.com
www.ultra-nspi.com
Ultra Electronics, Nuclear sensors & Process
Ultra Electronics, Nuclear sensors & Process
Instrumentation is a business name of Weed
Instrument Co., Inc
.
POWER: The MXCC-IP modules obtain power from
the 10+2 interconnection bus. Power originates from
an MX Base Module (see specification section).
CONTACT CLOSURE (DRY CONTACT) INPUT:
CONTACT CLOSURE (DRY CONTACT) INPUT:
The Port-1 I/O terminal block is at the top-front of the
unit. Port-2 is directly below it. On a 4 port model,
Port-3 is at the bottom-front of the unit with Port-4
directly below and behind it. Screw terminal blocks
are numbered from left-to-right as follows:
Important Notice - Before utilizing the product, the user should
determine the suitability of the product for its intended use. The
user assumes all risk and liability in connection with such use.
ULTRA ELECTRONICS’ WRITTEN WARRANTY FOR THE
PRODUCT IS MADE IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. The user's exclusive remedy for breach of Ultra
Electronics' written warranty shall be the repair or replacement of
such quantity of product which is proven to be defective. In no
case shall Ultra Electronics be liable for any special, incidental,
or consequential damages based upon breach of contract,
negligence, strict liability or other legal theory.
Approval Agency Controlled Document
No changes authorized without prior agency approval
Publication Number:
RM0900208 Rev. 0
EOTec MX Multiplexer Models
MXCC-IP2 / MXCC-IP4
2 & 4 Port Contact Closure
Input Modules
Installation Instructions
Original Instructions
Connections
Nuclear Sensors &
Process Instrumentation
MX Contact Closure
Input Modules
For use ONLY with the
EOTec MX Multiplexer Line