Weed Instrument 2S10 Contact Closure Transmitter Specification Guide
Connect the DIN Rail via the End Clamp (2A09)
to protective earth ground with low impedance.
The modules are grounded to PE when they are
snapped onto the DIN Rail.
to protective earth ground with low impedance.
The modules are grounded to PE when they are
snapped onto the DIN Rail.
When in operation, do not look directly into the
transmit optical port or use magnification or
focusing equipment to view optical output.
transmit optical port or use magnification or
focusing equipment to view optical output.
IEC 60825-1, Class 1 LED Product
FDA 21 CFR 1040.10 & 1040.11
CAUTION: Use of controls and/or adjustments or
the performance of procedures other than those
specified herein may result in hazardous radiation
exposure.
the performance of procedures other than those
specified herein may result in hazardous radiation
exposure.
Further technical information can be obtained by
contacting Weed Instrument Co., Inc., Fiber Optic
Products Group.
Phone:
contacting Weed Instrument Co., Inc., Fiber Optic
Products Group.
Phone:
1.800.880.9333
512.434.2850
Fax:
Fax:
512.434.2851
Email:
fiberop@weedinstrument.com
Visit:
www.weedinstrument.com
Safety and Warning Information
Important Notice - Before utilizing the product, the user should
determine the suitability of the product for its intended use. The
user assumes all risk and liability in connection with such use.
WEED INSTRUMENT'S WRITTEN WARRANTY FOR THE
PRODUCT IS MADE IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. The user's exclusive remedy for breach of Weed
Instrument's written warranty shall be the repair or replacement
of such quantity of product which is proven to be defective. In no
case shall Weed Instrument be liable for any special, incidental,
or consequential damages based upon breach of contract,
negligence, strict liability or other legal theory.
determine the suitability of the product for its intended use. The
user assumes all risk and liability in connection with such use.
WEED INSTRUMENT'S WRITTEN WARRANTY FOR THE
PRODUCT IS MADE IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. The user's exclusive remedy for breach of Weed
Instrument's written warranty shall be the repair or replacement
of such quantity of product which is proven to be defective. In no
case shall Weed Instrument be liable for any special, incidental,
or consequential damages based upon breach of contract,
negligence, strict liability or other legal theory.
Weed Instrument Co., Inc.
Round Rock, Texas, USA
www.weedinstrument.com
Publication Number:
RM0900124 Rev. 3/04
Weed Instrument
2S10
EOTec 2000 Multi-Channel
Contact Closure
Optical Transmit Module
Provides transfer of two channels of
contact closure information over a
single fiber to a partnered 2H07
For use with Multimode Glass Fiber,
ST* Compatible Fiber Connections,
850nm Optical Wavelength
Installation Instructions
Fiber Optics
Connections
Channel A
Channel B
1 2 3 4
1. NO CONNECT
2. SWITCH
3. NO CONNECT
2. SWITCH
3. NO CONNECT
4.
SWITCH
1 2 3 4
1. 24VDC
2. RETURN
3. RETURN
2. RETURN
3. RETURN
4.
24VDC
FIBER TRANSMIT
PORT
Note: Use shielded cable for all connections.
Power