Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Specification Guide

This section describes system error and recovery messages that may appear when a Cisco 2800 series 
router is operated. Cisco IOS software displays system error and recovery messages on an external 
device console terminal screen. (For more information, see the 

.)

The terminal should display one of the following prompts:

Router>

 (indicates the user EXEC command mode)

or

Router#

 (indicates the privileged EXEC command mode)

The Cisco IOS software checks the system condition once every 30 seconds. If the condition still exists, 
the error message appears again; if the error condition has cleared, a recovery message appears.

 describes system error and recovery messages and LED conditions that might accompany them.

 does not provide a complete list of system LED conditions. (For all LED conditions that can 

occur in your router, see the 

 and the 

.)

AIM0

AIM1

(Advanced integration 
modules)

Off

No AIM installed in slot 
(0, 1).

Indication is for information only.

Green

AIM in slot (0, 1) is 
initialized.

Normal indication. No action required.

Amber

AIM in slot (0, 1) failed to 
initialize.

Replace the AIM. To replace the AIM, refer to the 

 section of the 

” online document.

1.

The 3 blinks+pause state is applicable to the Cisco 2821 and Cisco 2851 routers only. The Cisco 2801 and Cisco 2811 do not have 1000 Mbps ethernet 
ports.

2.

The PVDM2 LED is applicable only to the Cisco 2821 and Cisco 2851 routers.