Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Specification Guide

Installing and Upgrading Internal Modules in Cisco 2800 Series Routers

OL-5792-04

Installing and Removing PVDMs

Figure 29

Removing a PVDM

Step 3

Place the PVDM in an antistatic bag to protect it from ESD damage.

Installing a PVDM

To install a PVDM, follow these steps.

Note

If installing only one PVDM, install it in PVDM connector 0. If installing two PVDMs, install the second
one in PVDM connector 1.

Step 1

Locate the PVDM connector on the system board. See

, or

depending on your router model, for the location of the PVDM connectors.

Step 2

Orient the PVDM so that the polarization notch lines up with the polarization key on the connector. See

Figure 28

Step 3

Hold the PVDM at an angle and insert it carefully into the PVDM connector. Tilt the PVDM up to the
vertical position so that the clips snap into place at both ends. See

Figure 30

Release clips

Tilt the PVDM

103468