Cisco CATALYST 6509E 9 SLOT 15U CHASSIS NO POWER SUPPLY NO FAN TRAY Specification Guide
B-18
Catalyst 6500 Series Switches Installation Guide
OL-5781-04
Appendix B Transceivers, Module Connectors, and Cable Specifications
Module Connectors
Figure B-11 RJ-45 Interface Cable Connector
Caution
Category 5e and Category 6 cables can store large levels of static electricity because of the dielectric
properties of the materials used in their construction. Always ground the cables (especially in new cable
runs) to a suitable and safe earth ground before connecting them to the module.
properties of the materials used in their construction. Always ground the cables (especially in new cable
runs) to a suitable and safe earth ground before connecting them to the module.
Caution
To comply with GR-1089 intrabuilding, lightning immunity requirements, you must use foil twisted-pair
(FTP) cable that is properly grounded at both ends.
(FTP) cable that is properly grounded at both ends.
RJ-21 Connector
The RJ-21 connectors (shown in
) are used on telco modules. Each RJ-21 connector has pins
for 12 ports.
Note
The RJ-21 connector for the WS-X6624-FXS module has pins for 24 ports. See the
.
To connect to 10/100BASE-TX RJ-21 telco interfaces, use Category 5 UTP cables with male RJ-21
connectors, as shown in
connectors, as shown in
. The WS-X6224-FXS analog interface module also uses an RJ-21
connector, but the pinout arrangement is different than the 10/100BASE-TX.
H1567
Pin 1
Pin 8
RJ-45 (both ends)
Warning
If the symbol of suitability with an overlaid cross appears above a port, you must not connect the
port to a public network that follows the European Union standards. Connecting the port to this type
of public network can cause severe personal injury or can damage the unit. Statement 1031
port to a public network that follows the European Union standards. Connecting the port to this type
of public network can cause severe personal injury or can damage the unit. Statement 1031