Cisco CATALYST 6509E 9 SLOT 15U CHASSIS NO POWER SUPPLY NO FAN TRAY Specification Guide

LEDs indicate all system states in the startup sequence. By checking the LEDs, you can determine when 
and where the system failed in the startup sequence.

To identify startup problems, follow these steps:

Turn on the power supplies. You should immediately hear the system fan assembly begin to operate. If 
you do not hear the fans operating, see the 

. If 

you determine that the power supplies are functioning normally and that the fan assembly is faulty, 
contact a customer service representative. If the system fan assembly does not function properly at initial 
startup, there are no installation adjustments that you can make. To replace the fan assembly, see the 

Verify that the LEDs on the supervisor engine light as follows:

The STATUS LED should flash orange once and stay orange during diagnostic boot tests. It turns 
green when the module is operational (online). If the system software is unable to start up, the 
STATUS LED stays orange.

The SYSTEM LED should turn green, indicating that all chassis environmental monitors are 
reporting that the system is OK. If one or more environmental monitor reports a problem, the 
SYSTEM LED is orange or red.

The ACTIVE LED should turn green, indicating that the supervisor engine is operational and active. 
If the supervisor engine is in standby mode, the ACTIVE LED is orange.

Each LINK LED should flash orange once and stay orange during diagnostic boot tests, and turn 
green when the module is operational (online). If no signal is detected, the LINK LED turns off. The 
LINK LED blinks orange if the port is bad. 

If any LEDs on the supervisor engine front panel are red or orange, see the 

.

If you have a redundant supervisor engine, refer to the Catalyst 6500 Series Switch Software 
Configuration Guide or the Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide 
publications for descriptions of how the redundant supervisor engine comes online and how the software 
images are handled.

For a complete description of the supervisor engine LEDs, refer to the Catalyst 6500 Series Switch 
Module Installation Guide.

Verify that the STATUS LEDs on the supervisor engine and on each switching module are green when 
the supervisor engine completes initialization. The STATUS LED indicates that the supervisor engine or 
switching modules are receiving power, have been recognized by the supervisor engine, and contain a 
valid Flash code version. This LED does not indicate the state of the individual interfaces on the 
switching modules. If a STATUS LED is red or orange, see the 

If the startup information and system banner do not display at startup, refer to the Catalyst 6500 Series 
Switch Module Installation Guide to verify that the terminal is set correctly and that it is connected 
properly to the supervisor engine console port.