Cisco CATALYST 6509E 9 SLOT 15U CHASSIS NO POWER SUPPLY NO FAN TRAY Specification Guide

After you install the system ground lug, follow these steps to correctly attach the ESD wrist strap:

Attach the ESD wrist strap to bare skin as follows:

If you are using the ESD wrist strap supplied with the FRUs, open the wrist strap package and 
unwrap the ESD wrist strap. Place the black conductive loop over your wrist and tighten the strap 
so that it makes good contact with your bare skin.

If you are using an ESD wrist strap equipped with an alligator clip, open the package and remove 
the ESD wrist strap. Locate the end of the wrist strap that attaches to your body and secure it to your 
bare skin.

Grasp the spring or alligator clip on the ESD wrist strap and momentarily touch the clip to a bare metal 
spot (unpainted surface) on the rack. We recommend that you touch the clip to an unpainted rack rail so 
that any built-up static charge is then safely dissipated to the entire rack.

Attach either the spring clip or the alligator clip to the ground lug screw as follows (See 

If you are using the ESD wrist strap that is supplied with the FRUs, squeeze the spring clip jaws 
open, position the spring clip to one side of the system ground lug screw head, and slide the spring 
clip over the lug screw head so that the spring clip jaws close behind the lug screw head.

The spring clip jaws do not open wide enough to fit directly over the head of the lug screw 
or the lug barrel.

If you are using an ESD wrist strap that is equipped with an alligator clip, attach the alligator clip 
directly over the head of the system ground lug screw or to the system ground lug barrel.