Cisco 7500 SERIES ROUTE SWITCH PROCESSOR 16 Specification Guide

Automatic synchronization mode is on by default. Therefore, unless you have disabled automatic
synchronization a manual update is not required. For more information about automatic synchronization,
see the

.

To set environment variables on the standby RSP when automatic synchronization is on, use the
following commands beginning in privileged EXEC mode:

To monitor and maintain HSA operation, you can override the standby image that is bundled with the
active image by using the following command in global configuration mode:

The slave image system command, previously used to determine which image the standby runs, is not
valid with newer images containing HA features.

Router(config)# boot system

(Optional) Specifies the system image that the router loads at
startup and stores it in the BOOT variable in the current running
configuration.

For a complete syntax description and usage guidelines,
refer to the Cisco IOS Configuration Fundamentals
Command Reference publication.

Router(config)# boot bootldr file-url

(Optional) Specifies the Flash file system and file name that ROM
uses at startup and stores it in the BOOTLDR variable in the
current running configuration

Router(config)# boot config file-url

(Optional) Specifies the location of the configuration file that the
router uses at startup and stores it in the CONFIG_FILE
environment variable in the current running configuration.

Router(config)# end

Exits global configuration mode and returns you to privileged
EXEC configuration mode.

Router# copy running-config startup-config

Saves the settings to the startup configuration. This also puts the
information under that RSP’s ROM monitor control.

Router# show bootvar

Verifies the environment variable settings.

Router(config)# hw-module slot image

Specifies which image the standby runs.