Cisco 7000 SERIES PA 8 PORT T1 MC ADAPTER WITH CSU DSU Specification Guide
3-16
Multichannel DS1/PRI Port Adapte Installation and Configuration
OL-3525-03
Chapter 3 Removing and Installing Port Adapters
Connecting an RJ-48C Shielded Cable
Connecting an RJ-48C Shielded Cable
On a single multichannel DS1/PRI
port adapter, you can use up to two (PA-MC-2T1), four
(PA-MC-4T1,) or eight (PA-MC-8T1 or PA-MC-8DSX1) RJ-48C connections. RJ-48C shielded cables
are not available from Cisco Systems; they are available from outside commercial cable vendors.
are not available from Cisco Systems; they are available from outside commercial cable vendors.
To connect RJ-48C shielded cables to the multichannel DS1/PRI port adapter, follow this procedure:
Step 1
Attach the Category 3 or 5 UTP shielded cable directly to one of the RJ-48C ports on the multichannel
DS1/PRI port adapter.
DS1/PRI port adapter.
Step 2
Attach the network end of your RJ-48C shielded cable to your external equipment.
Step 3
Repeat Steps 1 and 2 for each of the remaining interfaces you want to install.
Note
When you make a good connection of an RJ-48C shielded cable to a port on the multichannel
DS1/PRI port adapter, it takes approximately 30 seconds for the system software to report that
the line is up.
DS1/PRI port adapter, it takes approximately 30 seconds for the system software to report that
the line is up.
This completes the port adapter cable installation. Proceed to
to configure the port adapter and complete the installation.