Cisco 7000 SERIES PA 8 PORT T1 MC ADAPTER WITH CSU DSU Specification Guide
4-12
Multichannel DS1/PRI Port Adapter Installation and Configuration
OL-3525-03
Chapter 4 Configuring the Multichannel DS1/PRI Interfaces
Configuring the Interfaces
changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial3/1/1:0,
changed state to up
Router(config-controller)#
Step 7
Specify the interface to modify by entering the interface serial subcommand, followed by the interface
address of the interface you plan to configure.
address of the interface you plan to configure.
provides examples.
Step 8
Assign an IP address and subnet mask to the interface with the ip address configuration subcommand
as in the following example:
as in the following example:
Router(config-int)# ip address 1.1.15.1 255.255.255.0
Router(config-int)#
Step 9
Add any other configuration subcommands required to enable routing protocols and adjust the interface
characteristics.
characteristics.
Step 10
Use the no shutdown command to reenable the interfaces.
Step 11
After including all of the configuration subcommands, to complete the configuration, press Ctrl-Z (hold
down the Control key while you press Z) to exit configuration mode.
down the Control key while you press Z) to exit configuration mode.
Step 12
Write the new configuration to memory:
Router# write memory
The system displays an OK message when the configuration is stored.
Step 13
Exit the privileged level and return to the user level by entering disable at the prompt:
Router# disable
Router>
This completes the procedure for creating a basic channelized T1 configuration. Proceed to the
to check the interface configuration using show
commands. For additional information about configuring channelized T1 interfaces, refer to the
publications Wide-Area Networking Configuration Guide and Wide-Area Networking Command
Reference.
publications Wide-Area Networking Configuration Guide and Wide-Area Networking Command
Reference.
Configuring Multichannel T1 ISDN PRI Interfaces
Note
The Catalyst 6000 family FlexWAN module does not support ISDN.
Following are instructions for a basic multichannel T1 ISDN PRI configuration (enabling a controller
and specifying IP routing). You might also need to enter other configuration subcommands, depending
on the requirements for your system configuration and the protocols you plan to route on the interface.
For complete descriptions of configuration subcommands and the configuration options available, refer
to the publications listed in the
and specifying IP routing). You might also need to enter other configuration subcommands, depending
on the requirements for your system configuration and the protocols you plan to route on the interface.
For complete descriptions of configuration subcommands and the configuration options available, refer
to the publications listed in the
.
The PRI group must be mapped before the multichannel DS1/PRI controller can be configured (there is
only one PRI group for each controller). The following are controller commands used to map the PRI
group:
only one PRI group for each controller). The following are controller commands used to map the PRI
group:
•
isdn switch-type switch-type
•
controller t1 port-adapter-slot-number/interface-port-number (for Catalyst RSM/VIP2)