Cisco 7000 SERIES PA 8 PORT T1 MC ADAPTER WITH CSU DSU Specification Guide
4-24
Multichannel DS1/PRI Port Adapter Installation and Configuration
OL-3525-03
Chapter 4 Configuring the Multichannel DS1/PRI Interfaces
Checking the Configuration
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Chassis Interface.
2 VIP2 controllers (8 Ethernet)(8 T1).
8 Ethernet/IEEE 802.3 interfaces.
3 Serial network interfaces.
8 multichannel T1/PRI ports.
125K bytes of non-volatile configuration memory.
16384K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x0
Using the show diag Command
Display the types of port adapters installed in your system (and specific information about each)
using the show diag slot command, where slot is the port adapter slot in a Cisco 7100 series, Cisco 7200
series, Cisco uBR7200 series router, Cisco 7301 routers, Cisco 7401ASR router, and the interface
processor slot in a Catalyst 6000 family FlexWAN module, or a VIP in a Cisco 7000 series or Cisco
7500 series router.
using the show diag slot command, where slot is the port adapter slot in a Cisco 7100 series, Cisco 7200
series, Cisco uBR7200 series router, Cisco 7301 routers, Cisco 7401ASR router, and the interface
processor slot in a Catalyst 6000 family FlexWAN module, or a VIP in a Cisco 7000 series or Cisco
7500 series router.
Note
The slot argument is optional for Catalyst 5000 family switches.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
commands. The outputs in this document are examples only.
Catalyst RSM/VIP2 in Catalyst 5000 Family Switches
Following is an example of the show diag command that shows a DS1/PRI port adapter on a
Catalyst RSM/VIP2:
Catalyst RSM/VIP2:
Router# show diag 2
Slot 2:
Physical slot 2, ~physical slot 0xD, logical slot 2, CBus 0
Microcode Status 0x4
Master Enable, LED, WCS Loaded
Pending I/O Status: None
EEPROM format version 1
VIP2 controller, HW rev 2.4, board revision D0
Serial number: 04371939 Part number: 73-1684-03
Test history: 0x00 RMA number: 00-00-00
Flags: cisco 7500
EEPROM contents (hex):
0x20: 01 15 02 04 00 42 B5 T1 49 06 94 03 00 00 00 00
0x30: 68 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
[Additional display text omitted]
Catalyst 6000 Family FlexWAN Module
Following is an example of the show diag command that shows a PA-MC-8T1 port adapter on a
Catalyst 6000 family FlexWAN module:
Catalyst 6000 family FlexWAN module:
Router# show diag
[Additional display text omitted]
Slot 6: Logical_index 12