Cisco 7000 SERIES PA 8 PORT T1 MC ADAPTER WITH CSU DSU Specification Guide

Page of 108
 
4-27
Multichannel DS1/PRI Port Adapter Installation and Configuration
OL-3525-03
Chapter 4      Configuring the Multichannel DS1/PRI Interfaces
Checking the Configuration
                HW rev 1.C, Board revision A0
                Serial number: 04953593  Part number: 73-1556-07 
        PA Bay 1 Information:
                Multi-channel (T1) PA, 8 ports
                EEPROM format version 0
                HW rev FF.FF, Board revision UNKNOWN
                Serial number: 4294967295  Part number: 255-65535-255 
VIP in Cisco 7000 Series and Cisco 7500 Series Routers
Following is an example of the show diag slot command that shows a DS1/PRI port adapter in port 
adapter slot 0 on a VIP in interface processor slot 2:
Router# show diag 2
Slot 2:
        Physical slot 2, ~physical slot 0xD, logical slot 2, CBus 0
        Microcode Status 0x4
        Master Enable, LED, WCS Loaded
        Board is analyzed 
        Pending I/O Status: None
        EEPROM format version 1
        VIP2 controller, HW rev 2.4, board revision D0
        Serial number: 04371939  Part number: 73-1684-03
        Test history: 0x00        RMA number: 00-00-00
        Flags: cisco 7500
        EEPROM contents (hex):
          0x20: 01 15 02 04 00 42 B5 T1 49 06 94 03 00 00 00 00
          0x30: 68 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
        Slot database information:
        Flags: 0x4      Insertion time: 0x14A4 (00:23:00 ago)
        Controller Memory Size: 32 MBytes DRAM, 2048 KBytes SRAM
        PA Bay 0 Information:
                DS1/PRI PA, 1 port
                EEPROM format version 1
                HW rev 1.00, Board revision AO
                Serial number: 3549502 Part number: 73-2620-02
Using the show interfaces Command
The show interfaces command displays status information (including the physical slot and interface 
address) for the interfaces you specify. All of the examples that follow specify serial interfaces.
For complete descriptions of interface subcommands and the configuration options available for the 
Catalyst RSM/VIP2, Catalyst 6000 family FlexWAN module, Cisco 7100 series, Cisco 7200 series, 
Cisco uBR7200 series, Cisco 7301 routers, Cisco 7401ASR routers, and VIP interfaces in a Cisco 7000 
or Cisco 7500 series router, refer to the publications listed in the 
.
Note
The outputs that appear in this document may not match the output you receive when running these 
commands. The outputs in this document are examples only.