Cisco CATALYST 3524-PWR XL ENTERPRISE FAST ETHERNET 24 PORT SWITCH Specification Guide

Page of 2
Cisco Systems, Inc.
All contents are Copyright © 1992–2003 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
Page 1 of 2
Product Bulletin No. 2050
End-of-Sale and End-of-Life Announcement for the
Cisco Catalyst
3524-PWR
 Series XL Switch
Cisco Systems announces the end of life of the Cisco Catalyst
®
 3524-PWR Series XL Switch. The last
day to order the Cisco Catalyst 3524-PWR XL Switch will be August 12, 2003. Customers will continue to
receive support from the Cisco Technical Assistance Center (TAC) until August 12, 2008. Table 1 describes
the end-of-life milestones, definitions, and dates for the Cisco Catalyst 3524-PWR XL switch.
Customers are encouraged to migrate to the Cisco Catalyst 3550-24 PWR Intelligent Ethernet Switch, which
provides all of the advanced Layer 2–4 intelligent services available in the Catalyst 3550 Series along with integrated
inline power functionality. Customers can deploy high-performance IP routing, advanced quality of service (QoS),
granular rate-limiting, enhanced network security, and multicast management network-wide—while maintaining the
simplicity of traditional LAN switching. Additionally, up to 15.4W/port of inline power on every 10/100 port ensures
maximum device support for IP telephony and wireless LAN deployments.
Information about the Catalyst 3550-24 PWR Switch can be found at: http://www.cisco.com/go/catalyst3550
Table 1
End-of-Life Information for the Cisco Catalyst 3524-PWR XL Switch
Milestone
Definition
Date
End-of-life
announcement
The document that announces the end of sale and end of life
of a product to the general public.
February 10, 2003
End of sale
The last date to order the product through Cisco point-of-sale
mechanisms. The product is no longer for sale.
August 12, 2003
Last shipment
The last possible date that Cisco and/or its contract
manufacturers ship the affected product.
November 12, 2003
End of software
maintenance
releases
The last date that Cisco Engineering may release any final
software maintenance releases or bug fixes. After this date,
Cisco Engineering will no longer develop, repair, maintain, or
test the product software.
August 12, 2004
End of Routine failure
analysis date
The last possible date a routine failure analysis may be
performed to determine the cause of product failure or defect.
August 12, 2004
End of new service
attachment
For equipment and software that is not covered by a
service-and-support contract, this is the last date to order a
new service-and-support contract or add the equipment and/
or software to an existing service-and-support contract.
August 12, 2004
End of service
contract renewal
The last date to extend or renew a service contract for the
product. The extension or renewal period cannot extend
beyond the last date of support.
August 12, 2007 for HW/OS
Last date of support
The last date to receive service and support for the product.
After this date, all support services for the product are
unavailable, and the product becomes obsolete.
August 12, 2008 for HW/OS