LG OLED65B7A Owner's Manual

Page of 43
10
ENGLISH
Registering Magic Remote
How to Register the Magic Remote
To use the Magic Remote, first pair it with your TV.
1  Put batteries into the Magic Remote and turn 
the TV on.
2  Point the Magic Remote at your TV and press the 
 Wheel (OK) on the remote control.
 
f If the TV fails to register the Magic Remote, try 
again after turning the TV off and back on.
How to Deregister the Magic Remote
 
f Press the 
 and 
 (Home) buttons at the 
same time, for five seconds, to unpair the Magic 
Remote with your TV.
 
f Pressing and holding the 
 button will let 
you cancel and re-register Magic Remote at 
once.
 
f It is recommended that an Access Point (AP) 
be located more than 0.2 m (0.65 ft) away 
from the TV. If the AP is installed closer than 
0.2 m (0.65 ft), the Magic remote control 
may not perform as expected due to 
frequency interference.
Licenses
Supported licenses may differ by model. For more 
information about licenses, visit 
www.lg.com.
 
Open Source Software Notice 
Information
To obtain the source code under GPL, LGPL, MPL, 
and other open source licenses, that is contained in 
this product, please visit 
http://opensource.lge.com. 
In addition to the source code, all referred license 
terms, warranty disclaimers and copyright notices 
are available for download.
LG Electronics will also provide open source code 
to you on CD-ROM for a charge covering the cost 
of performing such distribution (such as the cost of 
media, shipping, and handling) upon email request 
to 
opensource@lge.com. This offer is valid for three 
(3) years from the date on which you purchased 
the product.
External Control Device Setup
To obtain the external control device setup 
information, please visit 
www.lg.com.
Troubleshooting
 
f Cannot control the TV with the remote control.
 
- Check if anything such as tape has been placed 
over the receiver.
 
- Check if there is any obstacle between the 
product and the remote control.
 
- Replace the batteries with new fresh ones.
 
f No image display and no sound is produced.
 
- Check if the product is turned on. 
 
- Check if the power cord is connected to a wall 
outlet.
 
- Check if there is a problem in the wall outlet by 
connecting other products.
 
f The TV turns off suddenly.
 
- Check the power control settings. The power 
supply may be interrupted.
 
- Check if the Timer Power Off / Sleep Timer 
feature is activated in the Timers settings.
 
- If there is no signal while the TV is on, the TV 
will turn off automatically after 15 minutes of 
inactivity.