Simple Control Simple Cable Emitter Owner's Manual
Copyright © 2015 by Roomie Remote, Inc.
1
Simple Cable - Emitter
Setup Guide
This document describes the Simple Cable - Emitter, which lets you control one device.
The Simple Cable - Emitter is available for
The Simple Cable - Emitter is available for
H
ARDWARE
S
ETUP
The Simple Cable - Emitter has a 3.5mm connector on one end that can attach:
•
Directly to a Simple Blaster: In this configuration, no other cables can be connected to the
Simple Blaster.
Simple Blaster.
•
To one port of a Simple Cable - Triport Adapter: In this configuration, the Simple Cable -
Emitter can be connected to any port of the Simple Cable - Triport Adapter.
Note: If you also intend on connecting a Simple Cable - Blaster to a port on the same Simple
Cable - Triport Adapter, the Simple Cable - Blaster can only be connected to Port 3, so you
would not want to attach the Simple Cable - Emitter to Port 3.
Emitter can be connected to any port of the Simple Cable - Triport Adapter.
Note: If you also intend on connecting a Simple Cable - Blaster to a port on the same Simple
Cable - Triport Adapter, the Simple Cable - Blaster can only be connected to Port 3, so you
would not want to attach the Simple Cable - Emitter to Port 3.
On the other end, the Simple Cable - Emitter has one emitter eye, which is used to control one
device. To affix the emitter eye: remove the backing, place the emitter eye directly over the
infrared receiver of the target device, and press firmly (test device control before removing
backing).
device. To affix the emitter eye: remove the backing, place the emitter eye directly over the
infrared receiver of the target device, and press firmly (test device control before removing
backing).
S
OFTWARE
C
ONFIGURATION
To configure a Simple Cable - Emitter:
1. Open the Simple Remote app, edit a room, and tap Add Device.
2. On the Add Device screen, tap Simple Blaster WiFi or Simple Blaster Ethernet.
3. On the Choose Port screen, tap the appropriate port:
1. Open the Simple Remote app, edit a room, and tap Add Device.
2. On the Add Device screen, tap Simple Blaster WiFi or Simple Blaster Ethernet.
3. On the Choose Port screen, tap the appropriate port:
Ø
If the Simple Cable - Emitter is directly connected to a Simple Blaster, select IR Port 1.
Ø
If the Simple Cable - Emitter is connected to a port on a Simple Cable - Triport Adapter,
select that port. For example, if the Simple Cable - Emitter is connected to Port 2 of the
Simple Cable - Triport Adapter, select IR Port 2.
select that port. For example, if the Simple Cable - Emitter is connected to Port 2 of the
Simple Cable - Triport Adapter, select IR Port 2.
4. Finish configuring the device.
5. Return to the Add Device screen and make any necessary changes, then tap Simple Blaster
5. Return to the Add Device screen and make any necessary changes, then tap Simple Blaster
Settings.