Simple Control Simple Cable Triple Emitter Owner's Manual
Copyright © 2015 by Roomie Remote, Inc.
1
Simple Cable - Triple Emitter
Setup Guide
This document describes the Simple Cable – Triple Emitter, which lets you control one device per
emitter.
The Simple Cable – Triple Emitter is available for
emitter.
The Simple Cable – Triple Emitter is available for
.
H
ARDWARE
S
ETUP
The Simple Cable – Triple Emitter has a 3.5mm connector on one end that must attach directly
to a Simple Blaster. The Simple Cable – Triple Emitter cannot be used with a Simple Cable -
Triport Adapter.
On the other end, the Simple Cable – Triple Emitter has three single-cable accessories:
to a Simple Blaster. The Simple Cable – Triple Emitter cannot be used with a Simple Cable -
Triport Adapter.
On the other end, the Simple Cable – Triple Emitter has three single-cable accessories:
•
Emitter 1: A single emitter cable with 1 gray band. Configure the device being controlled by
this emitter on IR Port 1. To affix the emitter eye: remove the backing, place the emitter eye
directly over the infrared receiver of the target device, and press firmly (test device control
before removing backing).
this emitter on IR Port 1. To affix the emitter eye: remove the backing, place the emitter eye
directly over the infrared receiver of the target device, and press firmly (test device control
before removing backing).
•
Emitter 2: A single emitter cable with 2 gray bands. Configure the device being controlled
by this emitter on IR Port 2. To affix the emitter eye: remove the backing, place the emitter
eye directly over the infrared receiver of the target device, and press firmly (test device
control before removing backing).
by this emitter on IR Port 2. To affix the emitter eye: remove the backing, place the emitter
eye directly over the infrared receiver of the target device, and press firmly (test device
control before removing backing).
•
Emitter 3: A single emitter cable with 3 gray bands. Configure the device being controlled
by this emitter on IR Port 3. To affix the emitter eye: remove the backing, place the emitter
eye directly over the infrared receiver of the target device, and press firmly (test device
control before removing backing).
by this emitter on IR Port 3. To affix the emitter eye: remove the backing, place the emitter
eye directly over the infrared receiver of the target device, and press firmly (test device
control before removing backing).