Pioneer AVIC-5201NEX Owner's Manual

En

 13

<CRD5002-A> UC

heater outlet.

This product

Truss head screw

(5 mm × 8 mm)

(6 pcs.)

Flush surface screw

(5 mm × 9 mm)

(6 pcs.)

Screw

(2 mm × 4 mm)

(1 pc.)

•  Fastening this product to the factory radio-

Position this product so that its screw holes are 

aligned with the screw holes of the bracket, and 

tighten the screws at three locations on each 

side. 

Use either the truss head screws (5 mm × 8 

mm) or flush surface screws (5 mm × 9 mm), 

depending on the shape of the bracket’s screw 
holes.

1

2

3

If the pawl interferes with installation, 

you may bend it down out of the way.

A

 Factory radio-mounting bracket

B

 Dashboard or console

C

 Truss head screw or flush surface screw  

Be sure to use the screws supplied with 

this product.

If you do not plan to remove the detachable 

faceplate, the detachable faceplate can be 

fastened with the supplied screw.

Screw (2 mm × 4 mm)

•  The antenna should be installed on a 

level surface where radio waves will 

be blocked as little as possible. Radio 

waves cannot be received by the 

antenna if reception from the satellite 

is blocked.

 Dashboard

 Rear shelf

•  When installing the GPS antenna inside 

the vehicle, be sure to use the metal  

sheet provided with your system. If this 

is not used, the reception sensitivity 

will be poor.

•  Do not cut the accessory metal sheet. 

This would reduce the sensitivity of the 

GPS antenna.

•  Take care not to pull the antenna lead 

when removing the GPS antenna. The 

lead may become detached.

•  Do not paint the GPS antenna, as this 

may affect its performance.