Pioneer AVIC-7201NEX Package Owner's Manual
Black plate (27,1)
! The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
allow the amps and navigation mechanism
to dissipate heat.
Do not cover this area.
! The semiconductor laser will be damaged
if it overheats, so don
’t install this product
anywhere hot
— for instance, near a heater
outlet.
Parts supplied
Parts marked (*) are supplied with AVIC-6200-
NEX and AVIC-5200NEX.
NEX and AVIC-5200NEX.
This product
Truss head screw
(5 mm × 8 mm)
(6 pcs.)
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)
Screw*
(2 mm × 4 mm)
(1 pc.)
Installation using the screw
holes on the side of this product
holes on the side of this product
% Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three locations
on each side.
Use either the truss head screws (5 mm ×
8 mm) or flush surface screws (5 mm ×
9 mm), depending on the shape of the brack-
et
radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three locations
on each side.
Use either the truss head screws (5 mm ×
8 mm) or flush surface screws (5 mm ×
9 mm), depending on the shape of the brack-
et
’s screw holes.
If the pawl interferes with installation,
you may bend it down out of the way.
you may bend it down out of the way.
1
2
3
1 Factory radio-mounting bracket
2 Dashboard or console
3 Truss head screw or flush surface screw
2 Dashboard or console
3 Truss head screw or flush surface screw
Be sure to use the screws supplied with
this product.
this product.
<CRD4951-A>27
En
27
English
Section
03
Installation