Sony MEX-M70BT Owner's Manual

Page of 42
26
GB
Troubleshooting
The following checklist will help you remedy 
problems you may encounter with your unit.
Before going through the checklist below, check 
the connection and operating procedures.
For details on using the fuse and removing the unit 
from the dashboard, refer to the installation/
connections manual supplied with this unit.
If the problem is not solved, visit the support site on 
the back cover.
General
No power is being supplied to the unit.
 If the unit is turned off and the display 
disappears, the unit cannot be operated with the 
remote commander.
 Turn on the unit.
No sound.
 The position of the fader control [FADER] is not 
set for a 2-speaker system.
No beep sound.
 An optional power amplifier is connected and 
you are not using the built-in amplifier.
The contents of the memory have been erased.
 The power supply lead or battery has been 
disconnected or not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes a noise when the position of the ignition 
is switched.
 The leads are not matched correctly with the 
boat’s accessory power connector.
During playback or reception, the demonstration 
mode starts.
 If no operation is performed for 5 minutes with 
[DEMO-ON] set, the demonstration mode starts.
 Set [DEMO-OFF] (page 21).
The display disappears from/does not appear in 
the display window.
 The dimmer is set to [DIM-ON] (page 21).
 The display disappears if you press and hold OFF.
 Press OFF on the unit until the display appears.
 The connectors are dirty (page 24).
The operation buttons do not function.
The disc will not eject.
 Press PTY/CAT and 
 (back)/MODE for more 
than 2 seconds to reset the unit.
The contents stored in memory are erased.
For your safety, do not reset the unit while you 
are driving.
Radio reception
Stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
 If your boat has built-in radio antenna (aerial) 
in the rear/side glass, connect an REM OUT 
lead (blue/white striped) or accessory power 
supply lead (red) to the power supply lead of a 
boat’s antenna (aerial) booster.
 Check the connection of the boat antenna 
(aerial).
 If the auto antenna (aerial) will not extend, 
check the connection of the power antenna 
(aerial) control lead.
 The tuning step setting has been erased.
 Set the tuning step again (page 8).
Preset tuning is not possible.
 The broadcast signal is too weak.
RDS
PTY displays [- - - - - - - -].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program type.
CD playback
The disc does not play back.
 Defective or dirty disc.
 The CD-R/CD-RW is not for audio use (page 22).
MP3/WMA files cannot be played back.
 The disc is incompatible with the MP3/WMA 
format and version. For details on playable discs 
and formats, visit the support site.
MP3/WMA files take longer to play back than 
others.
 The following discs take a longer time to start 
playback.
 A disc recorded with a complicated tree 
structure.
 A disc recorded in Multi Session.
 A disc to which data can be added.
The sound skips.
 Defective or dirty disc.
USB playback
You cannot play back items via a USB hub.
 This unit cannot recognize USB devices via a USB 
hub.
A USB device takes longer to play back.
 The USB device contains files with a complicated 
tree structure.