Brandmotion 9002-7601 Owner's Manual

9002-7601 

Instructions 

for 

printing.doc   Page 

1 

of 

5 

      GS 

Chassis Harness 

¼” Drill Bit  

Power Harness with RCA connectors 

Power Drill 

Camera mounted on license plate bracket 

Multi-meter or computer-safe test light 

Small bag containing: 

Ground Eyelet (recommended) 

Two license plate bolts [optional] 

Soldering Iron  

Male-to-male RCA adapter [not required] 

Wire Ties or Electrical Tape  

Alternate Camera Mount with Double-sided 

Adhesive Foam 

Solder (recommended) or T-Taps  
Plastic trim removal tool 

Instructions 

Rubber Grommet or Silicone Caulk 

(recommended) 

Vehicle service manual (if needed) 
Small sheet metal screws (recommended for 

Alternative Camera Mount install) 

•  Work in well ventilated area that is clear of obstructions. 

•  Secure vehicle with tire chucks in both front and rear of tires. 

•  Turn vehicle accessories OFF and ensure ignition key is in OFF position. 

•  Wear safety goggles and snug fitting clothes. 

•  Use tools only for their intended purpose and which are in good repair. 

•  Only perform this task if confidence, skill, and physical ability permit.