Fusion MS-AM504 Owner's Manual
FUSE
FUSE
Two Channel Installation
008
INST
ALLA
TION
Inputs & Gain Setup
Low Level Inputs
Be extra careful with your RCA interconnects. Hiss, engine noise, and fan noise can
easily be picked up through RCA cables if run incorrectly. Avoid running your RCAs near
large wire looms and electric fans if possible. Run your RCA cables on the opposite side
of the power cable. Be sure to check for correct balance (Red is right and black or white
is left)
easily be picked up through RCA cables if run incorrectly. Avoid running your RCAs near
large wire looms and electric fans if possible. Run your RCA cables on the opposite side
of the power cable. Be sure to check for correct balance (Red is right and black or white
is left)
Level Control
On the amplifier, is the LEVEL control, this control allows you to match the input level of the ampli-
fier to the output level of your head unit. Matching the input can be accomplished in three simple
steps:
fier to the output level of your head unit. Matching the input can be accomplished in three simple
steps:
1. Turn the LEVEL control on the amplifier to minimum.
2. Turn up the head unit and adjust to 2/3 maximum volume ensuring that the BASS and TREBLE
are set to zero.
are set to zero.
3. Adjust the LEVEL control until the desired volume is achieved without audible distortion.
Remember, the gain control is not a volume control. Ignoring the three steps above may leave you
with damaged speakers and/or a damaged amplifier.
with damaged speakers and/or a damaged amplifier.