Brandmotion 9002-8847 Owner's Manual
2632 Instructions 2-24-15.docx
Page 3 of 3
Dealer Programming Instructions
PARK VIEW REAR BACK-UP CAMERA
VEHICLE CONFIGURATION
Vehicle VIN must be updated with the sales code of the
added accessory in order to enable system functionality.
Using the DealerCONNECT website and the scan tool,
complete the procedure below:
added accessory in order to enable system functionality.
Using the DealerCONNECT website and the scan tool,
complete the procedure below:
A.
Log on to https://dealerconnect.chrysler.com
B.
In the “Vehicle Option” screen under “Global Claims
System” category in the “Service” tab, enter the
VIN and add the following sales code: XAC (PARK
VIEW REAR BACK-UP CAMERA) as a “Dealer
Installed Option.”
VIN and add the following sales code: XAC (PARK
VIEW REAR BACK-UP CAMERA) as a “Dealer
Installed Option.”
C. Confirm that the new sales code has been
successfully added to the VIN. With the scan tool
connected to both the internet (via Ethernet port or
wireless connection) and the vehicle, perform the
following steps:
connected to both the internet (via Ethernet port or
wireless connection) and the vehicle, perform the
following steps:
D.
Using the scan tool, select VEHICLE PREPARATION
and then select RESTORE VEHICLE
CONFIGURATION.
CONFIGURATION.
E.
Follow the step by step instructions on the scan
tool to complete the Park View Rear Back-Up
Camera vehicle configuration.
Camera vehicle configuration.
Step 23: Start vehicle and shift into Reverse in
order to check that all connections were made
properly. If all of the connections are correct you
will see the camera image displayed on your
factory display.
order to check that all connections were made
properly. If all of the connections are correct you
will see the camera image displayed on your
factory display.