Audiovox Voxx MTG13UHD Owner's Manual

23

This section is intended as an installation guide to connect the WM1 Module to the Unit  
  
NOTE: The WM1 Module is sold separately and is supplied with its own instruction manual.

1.  Turn the DVD Player over on a surface with protective covering to prevent 

scratches.

2. 

Begin looping the excess WM1 Module harness under the protective top plate 
towards the back of the DVD player as shown.

3. 

Place the WM1 Module onto the mounting standoffs.

4. 

Locate the four M3 x 5mm Screws in the Unit hardware kit. 

 

5. 

Using a screwdriver, install the four screws into the four locations shown.

          NOTE: Use caution tightening screws as the threads may strip in the assembly.

6. 

Insert the 8-pin connector of the WM1 Module harness into the location shown.

Back of Unit

Screw

Screw

WM1

8-pin Harness Connector