MTX ThunderForm Unloaded Enclosure Owner's Manual

MOUNTING LOCATION: The enclosure mounts in the trunk of the Mustang Coupe and Convertible on the rear passengers’ 
side.

TOOLS FOR INSTALLATION:
Powered Screwdriver   

 

 

#2 Phillips Head Bit

6” Bit Holder Extension   

 

 

Wire Cutters

INSTALLATION: Follow the steps below
1.   Place enclosure in passengers’ side of cargo area.

2.   Make note of the terminal location and then move enclosure aside to route wires to that location.

3.   Connect speaker wires from amplifier to enclosure, positive to red terminal and negative to black terminal.

4.  Fold the corner of the floor mat back under itself, as shown below.

5.  Place enclosure into corner of trunk with its front edge over the folded section of floor mat.  Make sure the enclosure is 

pressed firmly against the side walls of the trunk liner and tail light.