Nikon KeyMission 360 Owner's Manual

CT6K01(11)

Here, pairing refers to the setting used to connect the camera and smartphone or tablet (below, “smart device”) 
through Bluetooth.

Movie button

Photo button

Status lamps

Power-on lamp

Airplane mode switch

N-Mark

t Press and hold the movie button on the camera for about 3 seconds to turn it off. When the camera turns off, 

the power-on lamp turns off.

t Use a sufficiently charged battery so that the camera does not turn off during the procedure.
t Turn off the airplane mode switch on the camera. 
t Insert a microSD memory card with sufficient free space into the camera.

 

- Use microSDXC memory cards with a UHS Speed Class rating of 3 or faster when recording movies at an image 

size/frame rate of 2160/24p (4K UHD) or 1920/24p.

t Disconnect the HDMI cable or USB cable.

t Two types of apps are available: “SnapBridge” and “SnapBridge 360/170”. Use “SnapBridge 

360/170” when pairing with the KeyMission 360.

t Do not pair from the Bluetooth setting screen of the smart device.

1  Make sure that the camera is off (the power-on lamp is off ).

2  Enable Bluetooth and Wi-Fi on the smart device.

t Do not pair from the Bluetooth setting screen of the smart device.

3  Install and start the SnapBridge 360/170 app.

4  Press the movie button or photo button on the camera to put it into pairing standby mode. 

t When the status lamps flash green at the same time for a while and then alternately flash green, the camera 

enters pairing standby mode.

t If the camera remains in pairing standby mode for about 4 minutes, it turns off (the power-on lamp turns off ) 

automatically. If the camera turns off during the pairing procedure, press the movie button or photo button 
on the camera to put it into pairing standby mode.

* If the camera does not enter pairing standby mode even after pressing the movie button or photo button, 

press and hold the movie button for about 7 seconds while the camera is off.