Nikon KeyMission 360 Owner's Manual
14
Pairing with a Smartphone or Tablet
Re-pairing
Perform re-pairing in the following situations:
• When pairing the same smart device again after unpairing using End pairing in
the SnapBridge 360/170 app
• When pairing with a second smart device or more
1
2
Press and hold down the movie button
for about 7 seconds to put the camera
into pairing standby mode.
for about 7 seconds to put the camera
into pairing standby mode.
• When the status lamps flash green at the same
time for a while and then alternately flash green,
the camera enters pairing standby mode.
the camera enters pairing standby mode.
• If the camera cannot find the smart device, the
camera turns off automatically after remaining in
pairing standby mode for about 4 minutes.
pairing standby mode for about 4 minutes.
3
Start pairing.
• For iOS or NFC-incompatible Android devices:
Start the SnapBridge 360/170 app.
• For NFC-compatible Android devices:
Tap the NFC antenna of the smart device to the
Y (N-Mark) on the camera to start the
SnapBridge 360/170 app.
When Camera name acquired. Connect? is
displayed, select OK and proceed to step 5.
If the SnapBridge 360/170 app download site is
displayed on the smart device screen, repeat this
operation after installation.
Y (N-Mark) on the camera to start the
SnapBridge 360/170 app.
When Camera name acquired. Connect? is
displayed, select OK and proceed to step 5.
If the SnapBridge 360/170 app download site is
displayed on the smart device screen, repeat this
operation after installation.
Status lamps