AudioControl The Epicenter® Plus by AudioControl Owner's Manual

Quick Install Information   
Integration With A Factory Installed Audio System

We interrupt your reading of this manual to provide the impatient people with 

“Quick Install” information and guidelines.  No matter how much more of this 
manual you read, definitely look at the system drawings on page 10.  Not only 
will they help with system design, but if you look at them backwards you may 
find a hidden message (NOT!). 

As you have probably figured out by now, The Epicenter Plus needs to be 

installed in the signal path between a source and an external amplifier(s).  If your 
factory installed audio system has an amplifier, then use the speaker wires after 
the factory amplifier to feed a signal into The Epicenter Plus. 

The Epicenter Plus also works the best when it receives a full range signal.  If 

you feel your bass response is somewhat lackluster, then the frequency response 
of the signal you are feeding The Epicenter Plus may be too low.  Try finding a 
full range signal or use an AudioControl LC6i to sum the signals together. 

Once this is done, you just need to hook up power, ground, trigger, run the 

wire to the dash remote and tada!!!  Instant bass.  If you need to know more, 
then read on.  Heck if you don’t think you need to know more, you should still 
read on, because you can never know too much.

We now return you to your normal owner’s manual…