Yamaha AVENTAGE RX-A670 Owner's Manual

n

If your wireless router (access point) does not support WPS button configuration
method, follow the procedure below to configure the wireless network settings.

Press z (receiver power) to turn on the unit.

Operations with TV screen are available only when your TV is connected to the unit via HDMI.

Use the cursor keys (q/w) to select “Network” and press ENTER.

Use the cursor keys (q/w) to select “Network Connection” and
press ENTER.

Use the cursor keys (e/r) to select “Wireless(Wi-Fi)” and press
ENTER.

The unit may connect automatically to the access point to which it has connected previously. In this
case, the message indicating the successful connection will appear. You can ignore this message
and proceed to the next step.

Use the cursor keys (q/w) to select the desired connection
method and press ENTER.

The following connection methods are available.

You can set up a wireless connection with the WPS button while
viewing the TV screen. Follow the instructions displayed on the TV
screen.

You can set up a wireless connection by searching for an access
point. For details on settings, see “Searching for an access
point” (p.43).

You can setup a wireless connection by entering the required
information (such as SSID) manually. For details on settings, see
“Setting up the wireless connection manually” (p.44).

You can set up a wireless connection by entering the unit’s PIN
code into the wireless router (access point). The method is available
if the wireless router (access point) supports the WPS PIN code
method. For details on settings, see “Using the WPS PIN
code” (p.45).