Q-Logic Q-Forms Kick Panel Enclosures Owner's Manual
QL-K2005
Remove Original Kick Panel
• Remove original threshold plate by removing attachment screws.
• Carefully pull kick panel away from bulkhead to release mounting clip.
• Tilt lower front edge upward and remove panel from vehicle.
• Carefully pull kick panel away from bulkhead to release mounting clip.
• Tilt lower front edge upward and remove panel from vehicle.
Relocate Parking Brake Arm
• Carefully bend emergency brake pedal arm toward center of vehicle by approximately 1-1/2 inches.
• Check operation of unit to assure smooth actuation and release.
• Check operation of unit to assure smooth actuation and release.
NOTE: Always check the fit of the Q-Forms into the vehicle before any cutting or modifications are done.
Install Speakers
• Cut the speaker holes into the Q-Forms before installing them into the vehicle.
• Install the speakers into the Q-Forms after they have been installed into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface.
A die grinder or keyhole saw may also be used.
• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into mounting
surface. Be careful to center speakers in mounting surface to allow clearance for grill shell.
• Install tweeters as per manufacturer’s instructions.
• Install the speakers into the Q-Forms after they have been installed into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface.
A die grinder or keyhole saw may also be used.
• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into mounting
surface. Be careful to center speakers in mounting surface to allow clearance for grill shell.
• Install tweeters as per manufacturer’s instructions.
Install Q-Forms Kick Panels (Always predrill all mounting screw locations)
• Tilt tip of upper edge to allow it to slip under upper door seal molding.
• Rotate panel to position front edge tightly against rubber door seal.
• Reinstall threshold plate over rear edge of new kick panel.
• Install long screw and spacer into hole at rear of panel. Drive screw into
bulkhead sheet metal. It may be helpful to predrill screw pilot hole if power
tools are not available.
• Install grill shells by carefully pushing them into speaker mounting recesses.
• Rotate panel to position front edge tightly against rubber door seal.
• Reinstall threshold plate over rear edge of new kick panel.
• Install long screw and spacer into hole at rear of panel. Drive screw into
bulkhead sheet metal. It may be helpful to predrill screw pilot hole if power
tools are not available.
• Install grill shells by carefully pushing them into speaker mounting recesses.
QL-K2005 Included Hardware:
(2) 1" Screws
(2) 3" Screws
(2) 2 1/2" Plastic Spacers
(2) 6" x 8" polyfill pieces
(2) 6.25" Q-grills
(2) 3" Screws
(2) 2 1/2" Plastic Spacers
(2) 6" x 8" polyfill pieces
(2) 6.25" Q-grills
Estimated Installation Time: 1.5 Hrs.
Ford Explorer 1991-1994
inst ver 38.1