Q-Logic Q-Forms Kick Panel Enclosures Owner's Manual
QL-K3001
Dodge Ram Pickup 1994-1996
Remove Or
iginal Kick Panel / Threshold Plate
• Release threshold plate by carefully prying upward along bottom edge.
• Pull kick panel away from bulkhead to release mounting clips.
• Tilt bottom front edge upward and pull kick panel / threshold plate out of vehicle.
• Pull kick panel away from bulkhead to release mounting clips.
• Tilt bottom front edge upward and pull kick panel / threshold plate out of vehicle.
Modify Kick Panel / Threshold Plate
• Separate kick panel and threshold plate portions of part by cutting squarely across panel approximately 1.5
inches forward of forward most rectangular impression in threshold plate.
Modify Parking Brake Pedal
• Using two crescent wrenches, carefully bend brake pedal arm so that pedal pad is relocated approximately
1.5 inches to the right.
1.5 inches to the right.
NOTE: Always check the fit of the Q-Forms into the vehicle before any cutting or modifications are done.
Install Speakers
• Cut the speaker holes into the Q-Forms before installing them into the vehicle.
• Install the speakers into the Q-Forms after they have been installed into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface.
A die grinder or keyhole saw may also be used.
• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into mounting surface. Be careful to
• Install the speakers into the Q-Forms after they have been installed into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface.
A die grinder or keyhole saw may also be used.
• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into mounting surface. Be careful to
center speakers in mounting surface to allow clearance for grill shell.
• Install tweeters as per manufacturer’s instructions.
Install New Q-Forms Kick Panels (Always predrill all mounting screw locations)
• Lay Q-forms kick panel in approximate location and connect speaker wiring.
• Install panel into permanent position previously held by original kick panel.
• Install panel into permanent position previously held by original kick panel.
Be sure front edge of panel fits tightly against rubber door seal.
• Reinstall threshold plate by pushing mounting clips back into position. It
may be helpful to hold panel tightly against rubber door seal while pushing
forward clip into place.
forward clip into place.
• Install long screw and spacer through hole at rear of panel and drive into
inner bulkhead sheet metal. It may be helpful to predrill screw pilot hole if
installed without power tools.
installed without power tools.
• Install grill shells by pressing snugly into woofer cavity.
QL-K3001 Included Hardware:
(2) 3" Screws
(2) 2 1/2" Plastic Spacers
(2) 18" Rubber Welt Sections
(2) 6" x 8" polyfill pieces
(2) 6.25" Q-grills
(2) 2 1/2" Plastic Spacers
(2) 18" Rubber Welt Sections
(2) 6" x 8" polyfill pieces
(2) 6.25" Q-grills
Estimated Installation Time: 2.5 Hrs.
inst ver 42.1