Q-Logic Q-Forms Kick Panel Enclosures Owner's Manual

• Remove threshold plate by removing attachment screws.
• Remove screws from face of kick panel and pull away from bulkhead.
• Tilt bottom front edge upward, slide panel rearward to clear hood latch handle, and pull kick

panel out of vehicle.

• Cut the speaker holes into the Q-Forms before installing them into the vehicle.
• Install the speakers into the Q-Forms after they have been installed into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker
  mounting surface.  A die grinder or keyhole saw may also be used.
• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into
  mounting surface. Be careful to center speakers in mounting surface to allow
  clearance for grill shell.
• Install tweeters as per manufacturer’s instructions.

• Lay Q-forms kick panel in approximate location and connect speaker wiring.
• Install rubber welt to exposed metal edge extending vertically from bottom

of windshield molding to front edge of threshold plate.

• Install panel into permanent position previously held by original kick panel.

Be sure front edge of panel fits tightly against rubber welt.

• Reinstall threshold plate using original screws. Use supplied plastic trim

piece and 1" screw to secure panel to threshold plate.

• Install long screw and spacer through hole at rear of panel and drive into

inner bulkhead sheet metal. It may be helpful to predrill screw pilot hole if
installed without power tools.

• Install grill shells by pressing snugly into woofer cavity.

(2)  1.5" plastic spacers
(2)  2" screws
(2)  1" screws
(2)  14" rubber welt section
(2)  plastic trim pieces
(2)  6" x 8" polyfill pieces
(2)  6.25" Q-grills

inst ver 24.1