Yamaha YSP-2700 Digital Sound Projector Owner's Manual

PREPARATIONS

➤ d Connecting to a network

En

To use a wired network connection, connect the unit to a router via an STP network 
cable (category 5 or higher straight cable; not supplied).

• If the unit is already connected to a wireless network and you would like to switch to a wired connection, 

change “Network” in the setup menu to “Wired”.

d Connecting to a network

SYSTEM

CONNECTOR

INTELLIBEAM

MIC

R  AUX1  L

AUX2

TV

NETWORK

OUT (ARC)

UPDATE ONLY

SUBWOOFER

OUT

IN 1

HDMI

IN 2

IN 3

NETWORK

The unit (rear)

Internet

Network Attached Storage 

(NAS)

PC

Modem

Mobile device

Router

Network cable

To connect to a network, be sure that the unit is plugged into an AC wall outlet, and 
then connect the unit to a wireless router (access point).

Refer to the following for instructions on connecting to a wireless router (access 
point).

• Using the MusicCast CONTROLLER app (p. 50)

• Using connection methods other than the MusicCast CONTROLLER app (p. 53 to 

The 

 indicator on the front panel glows when the unit is 

connected to a wireless network.

• You cannot use the wireless network connection simultaneously with the 

wired network connection or Wireless Direct (p. 60).

• If the unit and the wireless router (access point) are too far apart, the unit may not connect to a wireless 

router (access point). In such case, place them close to each other.

• If the unit will not be connected to a wireless router (access point), Wireless Direct (p. 60) can be used 

to connect the unit directly to a mobile device to control the unit using the MusicCast CONTROLLER 
app installed on that mobile device.

The unit

Internet

Modem

Mobile device

Wireless router 
(access point)

Glows (green)