Yamaha YSP-2700 Digital Sound Projector Owner's Manual

SETTINGS

➤ Setup menu

En

When “AUTO SETUP” in the “IntelliBeam” menu (p. 33) is used, recommended beam settings are automatically applied by this unit. However, “Horizontal Angle”, “Beam Travel 
Length”, “Focal Length” (except “Center”), and “Image Location” settings can later be fine-tuned.

The output method for each channel can also be specified in “Beam” menu.

• When manually adjusting sound beams for the front channels, set “Front” for “Channel Out” to “Beam” or “Mix”. Adjustment is not possible if “Front” is set to “Stereo”.

Adjust the horizontal angle of sound beams for each channel using test tones.

Adjust toward L (left) to move the direction of the output to the left and adjust toward R 
(right) to move it to the right.

Front L, Front R, Center, Surround L, Surround R

L90° to R90°

Specify the distance that sound beams travel for each channel. The distance starts at 
this unit, ends at the listening position, and includes refraction off a wall. The audio 
delay is adjusted and sound from each channel arrives at the listening position 
simultaneously.

Front L, Front R, Center, Surround L, Surround R

0.3 m to 24.0 m (1.0 ft to 80.0 ft)

• Configure this setting only when you have adjusted “Horizontal Angle”.

➜

➜

Beam angle

Angle to

left

Angle to 
right

Left

W key:
Increase angle.

X key:
Decrease angle.

Right

X key: 
Increase angle.

W key: 
Decrease angle.

➜

➜

The length of each 
arrow indicates the 
beam travel length.