Yamaha YSP-2700 Digital Sound Projector Owner's Manual
SETTINGS
➤ Updating the unit’s firmware
En
93
4
Press the ENTER key.
The TV screen goes black and firmware update begins.
Update progress is displayed on the front panel display while firmware is
updated.
updated.
5
When “Success!” is shown in the front panel display, press the z
key on the unit’s top panel.
key on the unit’s top panel.
The firmware update is complete.
• If the firmware update fails, use the z key to turn the unit off and then on again, and repeat the procedure
from step 1 again.
• If “XXXXSumError” is displayed, a problem with communications over the network has occurred. Check
communications status, use the z key to turn the unit off and then on again, and then repeat the procedure
from step 1 again.
from step 1 again.
Updating firmware with connection of a USB flash drive
Download the latest firmware version from the Yamaha website to a USB flash drive,
which can then be used to update the unit’s firmware.
which can then be used to update the unit’s firmware.
See information provided when updating firmware for details.
1
Save this unit’s firmware to a USB flash drive.
2
Turn off the unit.
3
Connect the USB flash drive to the UPDATE ONLY jack on the unit’s
rear panel.
rear panel.
4
Select “FW UPDATE” in the advanced setup menu, and press the
ENTER key.
ENTER key.
5
Use
S/T key to select “Start OK?”, and press the ENTER key.
The firmware update begin.
Update progress is displayed on the front panel display while firmware is
updated.
updated.
6
When “Success!” is shown in the front panel display, press the z
key on the unit’s top panel.
key on the unit’s top panel.
The firmware update is complete.
• If the firmware update fails, use the z key to turn the unit off and then on again, and repeat the procedure
from step 1 again. If the firmware update fails again, confirm the USB flash drive is correctly connected to
the UPDATE ONLY jack.
the UPDATE ONLY jack.
• If any of the following messages are displayed, a problem has occurred during the update.
– “Not found”:
The USB flash drive does not contain the firmware data. Use a PC to properly save the firmware data to
the USB flash drive again.
the USB flash drive again.
– “XXXXSumError”:
There is a problem with the data stored on the USB flash drive. Use a PC to confirm data on the USB
flash drive.
flash drive.
FW Update
Success!
The update progress is displayed.
FW Update
Success!
The update progress is displayed.