Yamaha YSP-5600 Digital Sound Projector Owner's Manual

PREPARATIONS

➤ f Initial settings

En

The “AUTO SETUP COMPLETE” screen closes.

The IntelliBeam microphone is sensitive to heat, so should 
not be placed anywhere where it could be exposed to direct 
sunlight or high temperatures (such as on top of AV 
equipment).

❑

“Beam optimize only” or “Sound optimize only” can be measured 
separately in the setup menu.

See “Installing the IntelliBeam microphone” (p. 29) for 
instructions on positioning the IntelliBeam microphone.

S/T key to select “Beam” and then press 

S/T key to select “IntelliBeam” and then 

S/T key to select one of the items below 

For details on connecting IntelliBeam microphone, refer to 
“Using AUTO SETUP (IntelliBeam)” (p. 30).

Follow steps 4, 5, and 6 under “Using AUTO SETUP 
(IntelliBeam)” to configure settings, and then 
remove the microphone.

• When the AUTO SETUP procedure is performed from the setup menu, the menu 

selection screen of the setup menu appears. Press the SETUP (

) key twice to 

exit the setup menu.

Select this optimization feature if you make 
settings for the first time. This menu takes 
about 3 minutes.

Use to optimize the beam angle so that the 
parameter best matches your listening 
environment. This menu takes about 1 
minute.

Use to optimize the beam delay, volume, 
and quality so that the parameters best 
match your listening environment. This 
menu takes about 2 minutes.
You must optimize the beam angle with 
“Beam optimize only” before starting 
“Sound optimize only”. Select this 
optimization feature in the following cases:
• If you have opened or closed the curtains 

in your listening room before using this 
unit

• If you have manually set the beam angle 

with “Beam optimize only”.

//
ENTER
SETUP (    )