Netgear AC1900 Nighthawk™ Owner's Manual

Select ADVANCED > Advanced Setup > Remote Management. 

Select the Turn Remote Management On check box.

In the Allow Remote Access By section, specify the external IP addresses to be allowed to 
access the modem router’s remote management:

For enhanced security, restrict access to as few external IP addresses 
as practical

Select one of the following:

To allow access from a single IP address on the Internet, select the Only This 
Computer radio button. Enter the IP address to be allowed access. 

To allow access from a range of IP addresses on the Internet, select the IP Address 
Range radio button. Enter a beginning and ending IP address to define the allowed 
range. 

To allow access from any IP address on the Internet, select the Everyone radio 
button. 

Specify the port number for accessing the web management interface.

Normal web browser access uses the standard HTTP service port 80. For greater 
security, enter a custom port number for the remote web management interface. Choose 
a number from 1024 to 65535, but do not use the number of any common service port. 
The default is 8080, which is a common alternate for HTTP.

Click the Apply button.

Your changes take effect.



Launch an Internet browser on a computer that is not on your home network.

Type your modem router’s WAN IP address into your browser’s address or location field 
followed by a colon (:) and the custom port number. 

For example, if your external address is 134.177.0.123 and you use port number 8080, 
enter http://134.177.0.123:8080 in your browser.